PRESENTATION
Esoflat JPI 7034 is a reported profile (rabbet to be provided) for the treatment of expansion joints from 20 to 50mm. In the case of paving or industrial floors having to support a heavy traffic forklift-type wheeled vehicles traveling at a speed <20Km / h. Please note that this product does not support vertical flush dices, treatment of the slabs by dowelling is recommended. In the case of machines fitted with a solid tire wheel offering a reduced bearing surface of around 20cm2 and intense punching, we will guide you on our ranges of comb profiles, such as Esoflat JPI 4193, 4194, 4195S. The profiles with comb avoid the phenomenon of projection when crossing them DTU concerned: Tiling, ceramic, stone or similar in glued or sealed installation, (DTU 52.1, 52.2) Screeds, slabs based on hydraulic binder (DTU 26.2) Pavings (DTU 13.3 part 1 industrial paving)
Use
Supported traffic (according to DIN 1072):
Supported traffic (according to DIN 1055):
Punching supported 100Kg / cm wheel width on solid tire, pallet truck or stacker type from 1.5 to 2T.
For higher constraints, refer to our range ofESOFLAT JPI 4193, 4194 or 4195S.
Stainless steel recommended for configuration in places with permanent humidity (outdoor environment, cold room, steaming room, saline environment or other).
Packaging
Length of 3 meters with countersunk holes (M8) every 240 mm (2x13perc / ml),
The profile comes pre-assembled and wedged at the opening (side C) using 4 weld points per length, which facilitates installation. These welds must be ground immediately after installation (see plan view below).