ESOFLAT JPS S

PRESENTATION

Esoflat JPS S is a shutter system allowing to treat expansion joints of 30mm (JPS S30 and S35) or 45mm (JPS S55 and S60), in floor / floor or floor / wall configuration.
Composed of aluminum profiles, monolithic or modular (head + height angle) and a soft filling, accepting multidirectional amplitudes which are functions of the type of garnish used. These garnishes are interchangeable and heat-sealable.

System impervious to washing water, not stagnant (cleaning with karcher to avoid)

DTU concerned:
Tiling, ceramic, stone or similar in glued or sealed installation, (DTU 52.1, 52.2)
Screeds, slabs based on hydraulic binder (DTU 26.2)
Flooring glued textile or PVC (DTU 53.1, 53.2)

Use

Tertiary buildings such as stations, airports, schools, hospitals, shopping centers, offices, etc.

Supported traffic:

  • pedestrian, light vehicles, light handling equipment on tires (cleaning, transport of goods)
  • shopping carts on solid rubber wheels
  • heavy goods vehicles and occasional vans traveling at a speed of ≤ 10 km / h
  • load supported according to DIN 1072, on 2 tires with a surface area of 200 × 200 mm (see table below)

Aluminum alloy profiles being sensitive to corrosion by electrolysis, their installation in places with permanent humidity is not recommended (outdoors, cold rooms, saline environments). In this case use the stainless steel series (Esoflat JPS S Ai) or consult us.

If exposed to permanent humidity, clean the floor covering with corrosive products, diluted acids or others, avoid any infiltration between the screed and the aluminum profile by applying a mastic such as Esoflex Sil, PU or Korapop 225 at the interface of flooring and aluminum profiles having a section of about 5mm wide by 10mm high.
Putty to put in place depends on the type of attack, consult us for more information.

Packaging

Lateral metal profiles all models (3 ml bars in raw aluminum)

  • Standard: AGS T5 6060 aluminum alloy (all models)
  • Special: CU Zn 40 Pb1 brass alloy (Esoflat JPS S 40 × 40, head of the Esoflat JPS S60 range from height 18 to 53mm)
  • Our profiles are oblong perforated over all their lengths guaranteeing a homogeneous connection of the profile between the concrete slab and the finishing coating + 12 perc./bar in 6mm diameter used for fixing on the slab.

Very good chemical inertia.

Soft gaskets type G 30 or 50 (roll of 24 ml or multiple of 3 meters)

  • SEBS thermo-welding elastomer,
  • Standard colors: Gray, Black, Stone tone
  • Density (ASTM D792): 0.94
  • Shore A hardness (ISO 868.85): 67 ± 5
  • Elongation at Break (ASTM D412.A): 500%
  • Stress at break (ASTM D412.A): 6.1 MPa
  • Operating temperature: - 50 ° C to + 110 ° C
en_GBEnglish (UK)